Drilling and blasting

From Freepedia

Before the advent of tunnel boring machines, drilling and blasting was the only economical way of excavating long tunnels through hard rock, where digging is not possible.

History

While drilling and blasting saw limited use in pre-industrial times using gun powder, it was not until more powerful (and safer) explosives, e. g. dynamite, and powered drills were developed, that its potential was fully realised.

Drilling and blasting was succesfully used to construct tunnels throughout the world, notably the St. Gotthard Tunnel, or the Jungfraubahn.

Procedure

As the name suggests, drilling and blasting works as follows:

A number of holes are drilled into the rock, which are then filled with explosive. Detonating the explosive will cause the rock to collapse and thus lengthen the tunnel.

Repeating these steps will eventually result in a tunnel.

The positions and depths of the holes (and the amount of explosive each hole recieves) are determined by a carefully constructed pattern, which, together with the correct timing of the individual explosions, will guarantee that the tunnel will have an approximately circular cross-section.