Hawker Typhoon

From Freepedia

Hawker Typhoon
Image:Hawker.typhoon.rcaf.750pix.jpg
Royal Canadian Air Force Typhoon
Description
Role ground attack
Crew 1
First flight February 1940
Entered service
Manufacturer Hawker, Gloster
Dimensions
Length ft in9.75 m
Wingspan ft in12.7 m
Height ft in4.7 m
Wing area ft²25.92 m²
Weights
Empty lb 3992 kg
Loaded lb 5171 kg
Maximum takeoff lb 5171 kg
Capacity
Powerplant
Engine Sabre IIA
Power 2,200 hp 1626 kW
Thrust lb kN
Performance
Maximum speed mph652 km/h at 5485 m
Combat range miles km
Ferry range miles 821 km
Service ceiling ft 10,365 m
Rate of climb ft/min m/min
Armament
Guns 4 x Hispano 20mm cannons
Bombs 2 x 450 kg bombs
Missiles
Rockets 8 x 60 lb rockets
Other

The Typhoon was a British single-seat fighter aircraft, produced by Hawker Aviation starting in 1941. Intended as a replacement for the Hawker Hurricane in the interceptor role, it suffered from performance problems, and it instead evolved into one of World War II's most successful strike fighters.


Contents

History

Even before the new Hurricane was rolling off the production lines in March 1937, Sidney Camm had moved on to designing its future replacement as a private project. This was to be a massive plane designed around the equally massive Napier Sabre engine. The work proved useful when Hawker received specification F.18/37 in January 1938 from the Air Ministry, which asked for a fighter based around either the Napier Sabre or the Rolls-Royce Vulture engine. The engines were similar in that they were both 24 cylinder designs that were designed to deliver over 2,000 hp (1.5 MW), and different primarily in the arrangement of the cylinders - an H-block in the Sabre and an X-block in the Vulture.

The two resulting models became known as the 'R' and 'N' (based on the engine manufacturer) and were very similar – the Vulture powered R plane had a rounder nose profile and a ventral radiator, whereas the Sabre powered N had a flatter deck and a chin mounted radiator. The basic design of both continued the Hawker tradition of using 'older' construction techniques; the front fuselage was welded steel just like the Hurricane, and the design used a massive 40 foot (12 m) wing that was much thicker than those on designs like the Spitfire. Camm did give in to the times for much of the rest of the plane though, it was semi-monocoque from the cockpit rearward, flush riveted, and had wide set gear. Instead of sliding or lifting canopy the Typhoon came with a side door.

The R version first flew in October 1939, and the RAF was so impressed they ordered 1,000 as the Tornado. Various problems, notably compression effects which were previously unknown to Hawker, slowed the acceptance down. In addition the plane had rather disappointing climb performance, which meant it wouldn't be the Spitfire-replacing interceptor they were looking for. In February 1940 the first N model, now known as the Typhoon, was delivered. The RAF placed a large order for it as well, but moved production to Gloster Aircraft who had no designs to produce at the time. Like the Tornado, the Typhoon was soon demonstrating its own problems, including vibrations from the engine causing the wing skinning to peel.

Eventually the RAF cancelled all work on both models in May 1940 so that Hawker could concentrate solely on the Hurricane during the Battle of Britain. This was the design's first brush with death. Some small-scale work continued, changes to streamline the fuselage and supply a much thinner wing were looked at, as well as alternate engines in the form of large radials. In October pressure on the RAF eased and work was allowed to continue on the two original designs.

The first full production version Tornado was delivered in early 1941 and demonstrated the then unheard of speed of 425mph fully armed. This was also the last Tornado. While production lines were being drawn up, the Vulture engine project was suddenly terminated by Rolls-Royce and the Tornado was left without an engine.

Luckily, the Typhoon had 'good enough' performance to warrant production. The first production Mk.IA was delivered in May 1941 with twelve Browning .303 guns, but this was followed quickly with the Mk.IB with four Hispano 20 mm cannons.

By this time the Spitfire Vs were meeting Focke-Wulf Fw 190s in combat and getting rather beat up, so the Typhoon was rushed into squadron service to counter the new German plane. Sadly this proved to be a disaster. An apparent structural weakness in the tail meant that it tended to break off when pulling out of dives, the Fw's favourite escape. Once again there was talk of killing the design. The cause of these tail-failures (in which only one of the pilots survived to give any clue to the reason) was found to be fatigue failure of the elevator mass-balance, allowing elevator-flutter to occur which was at its greatest when pulling-out of a dive. As a "temporary" measure, rectangular strengthening "fishplates" were riveted around the fuselage/empennage joint - the site of the failures. These fishplates remained a feature on all subsequent Typhoons.

It wasn't until 1943 that the various problems with the airframe and engine had finally started to be worked out of the system. By this time the need for a pure fighter was no longer important and the design was converted into a fighter-bomber – much like the Hurricane had before it. The powerful engine allowed the plane to carry a massive load of up to two 1,000 lb (450 kg) bombs, with which the aircraft were nick-named "Bombphoons", although it would become much more famous with four 60 lb (27 kg) RP-3 rockets under each wing - the so-called "Rocketphoons".

The Mk.IB, now widely known as the Tiffy, distinguished itself particularly in the Battle of Normandy. In one famous case Tiffies of the 2nd Tactical Air Force decimated a large concentration of armor ahead of Avranches, disposing of no fewer than 137 tanks, and opening the way for the liberation of France and Belgium. For use in the tactical reconnaissance role, the Typhoon FR.IB was developed early in 1945. In this version the two inboard cannon were removed and three F.24 cameras were carried in their place. One Typhoon was also converted as a prototype night fighter, the NF.Mk IB was fitted with A.I. (Airborne Interception - ie., radar) equipment, special night-flying cockpit and other modifications. Production of the Typhoon, entirely by Gloster, was 3,330 machines.

Hawker developed an improved version of the Typhoon, the Typhoon II but the differences between it and the Mark I were so great that it was effectively a different plane, the Hawker Tempest.

Squadron Use

Specifications: Hawker Typhoon Mk 1B

General characteristics

  • Crew: One
  • Length: 9.74 m (31 ft 11.5 in)
  • Wingspan: 12.67 m (41 ft 7 in)
  • Height: 4.67 m (15 ft 4 in)
  • Wing area: 25.9 m² (279 ft²)
  • Weight
    • Empty: 8,800 lb (4,000 kg)
    • Loaded: 11,400 lb (5,200 kg)
    • Maximum takeoff: 11,400 lb (5,200 kg)
  • Powerplant:


Performance

  • Maximum speed: 405 mph at 18,000 ft (650 km/h at 5,500 m)
  • Range: 510 mi (820 km)
  • Service ceiling: 34,000 ft (10,400 m)
  • Rate of climb: 7.6 minutes to 20,000 ft (6,100 m)
  • Wing loading: lb/ft²)
  • Power/weight:

References:

  • Reed/Beamont - Typhoon & Tempest at War - Ian Allen - ISBN 0-7110-0542-7
  • The Illustrated Encyclopedia of Aircraft, vol 9, Iss. 106, pg 2120

See also

Related content
Related development

Hawker Tempest - Hawker Fury - Hawker Sea Fury - Hawker Tornado

Similar aircraft

Hawker Tornado

Designation series
Related lists

List of aircraft of the RAF


Lists of Aircraft | Aircraft manufacturers | Aircraft engines | Aircraft engine manufacturers

Airports | Airlines | Air forces | Aircraft weapons | Missiles | Timeline of aviation



Views
Personal tools
In other languages
Similar Links